S5 PROBLEM

check the start conditions
Важно - Какие условия должны соблюстись что бы мульт дал команду на старт | СервисКомп форум по ремонту радиоэлектронной аппаратуры

 

Before pressing the power button:
0. when the main BIOS and EC-BIOS are 100% working.
1. when there is a power supply to the cartoon, its quartz works and the cartoon BIOS subtracts (watch the data exchange on the BIOS flash drive with an oscilloscope).
2. when ACIN = 3.3 V
3. When LID_SW# = 3.3 V
After pressing the power button:
4. when the cartoon removes the reset from the South, i.e. EC_RSMRST# = 3.3 V
5. When pressing the power button, the ON/OFFBTN# signal drops to zero and the same signal is transmitted to PBTN_OUT#
6. When from the South the signal PM_SLP_S3# and SLP_S5# will be reset, i.e. the voltage on them will be 3.3 V.
Under these conditions, the cartoon should give the command to start.